|
Author
|
Topic: Sm57
|
Paul Norris
Member From: Andalusia,Ala. U.S.A.36420
|
posted 05 May 2003 11:47 AM
profile
I use this mike to mike my nv 400,but when I went to use it the other night it would not work. Later when I got it home ,I took it apart and all the wires were broken at the soilder points.looks like it had been taken apart.( maybe someone swaped).Does anyone have the wiring diagram so I might put these wires back on. Thanks |
Brad Sarno
Member From: St. Louis, MO USA
|
posted 05 May 2003 01:41 PM
profile
Are you looking at the wire points inside the mic where the body unscrews or are you looking at the xlr pin connections?brad sarno
|
Paul Norris
Member From: Andalusia,Ala. U.S.A.36420
|
posted 05 May 2003 06:10 PM
profile
It is where the head unscrews from the body.The small black wire that is on the screw post inside is my main concern, but help with all of it is most welcome. Thanks: |
Joey Ace
Sysop From: Southern Ontario, Canada
|
posted 05 May 2003 06:57 PM
profile
 |
Brad Sarno
Member From: St. Louis, MO USA
|
posted 05 May 2003 08:29 PM
profile
The black wire from the center of the capsule goes into the lower part of the mic and should be soldered to that copper strip which then has a black wire that goes down all the way to pin 1 on the xlr jack. It's the ground wire. The two colored wires go to the transformer that's tucked down inside beneath the copper strip. Brad Sarno |
Paul Norris
Member From: Andalusia,Ala. U.S.A.36420
|
posted 06 May 2003 11:40 AM
profile
Thanks guys, you have been a big help. Let me know if I can help either of you. |
Joey Ace
Sysop From: Southern Ontario, Canada
|
posted 06 May 2003 12:42 PM
profile
You welcome, Paul.related comment here |
The Steel Guitar Forum
