|
Author
|
Topic: mod's
|
Don Discher
Member From: Sault Ste Marie,Ontario,Canada
|
posted 01 December 2003 06:28 PM
profile
Is there a difference in the Peavey Mod and the John Lemay Miracle audio Super Mod or are they the same thing ?I want to do my Nashville 400 with one or the other. |
jay thompson
Member From: east peoria, il USA
|
posted 01 December 2003 08:38 PM
profile
Don,
As I recall, about $50 American.
Regards,
Jay Thompson |
Donny Hinson
Member From: Balto., Md. U.S.A.
|
posted 02 December 2003 03:35 PM
profile
The Peavey kit is less expensive, but I don't think it gives quite the low-end boost that the LeMay kit seems to give. If you're not into a "fat sound", go with the Peavey kit. Either one will give a substantial improvement to the stock amp. |
Mike Brown
Member From: Meridian, Mississippi USA
|
posted 04 December 2003 06:54 AM
profile
What the LeMay mod does not consider, is that too much low frequency in an opened back cabinet can cause failure of the speaker. A failure such as this is not covered under the Peavey warranty policy. Mike Brown
Peavey Electronics Corporation |
r johnson
Member From: flatrock mi
|
posted 04 December 2003 07:17 PM
profile
Just had the Peavey mod kit installed on my NV400 it is amazing how much difference it make in the sound. Go For It!!! |
Murnel Babineaux
Member From: Jennings, Louisiana, USA
|
posted 10 December 2003 10:56 PM
profile
I install and highly recommend these upgrade components in your Peavey amp.Check out some more info here:
http://www.cajunsteelguitar.com/id13.html Thanks, MB |
John Lazarus
Member From: Tucson, AZ.
|
posted 11 December 2003 08:55 AM
profile
Mike Brown- How do I order the mod for a Session 400 Limited? Are there instructions included to do it myself? How much does the kit cost?
Thanks. |
Mike Brown
Member From: Meridian, Mississippi USA
|
posted 19 December 2003 06:38 AM
profile
Hello John,
Thank you for inquiring and for your support of Peavey products. You can order the Nashville 400 Limited mod kit through your local authorized Peavey dealer or through our Parts Department here at the factory. Our number is (601)483-5365 or at parts@peavey.com The kit number is #90500048 and carries a U.S. MSRP of $29.98 and can be installed by a qualified technician in approximately an hour's time. The kit includes a "to" and "from" parts list with location designation and an original Nashville 400 schematic. Here is a link to the kit from our website;
http://www.peavey.com/media/pdf/steelguitar/nsh400mo.pdf It also includes a circuit board layout. If you have questions, I will be glad to answer them for you. NOTE:ALL NASHVILLE 400'S PRIOR TO 08575462 HAD THIS KIT INSTALLED AT THE FACTORY PRIOR TO SHIPMENT.
Mike Brown
Peavey Electronics Corporation |
The Steel Guitar Forum
