Author
|
Topic: Allen Wrench sizes for Zum?
|
Billy Murdoch Member From: Glasgow, Scotland, U.K.
|
posted 07 September 2005 07:43 AM
profile
I have a recently acquired Zum D10 and the Allen wrench sizes are confusing me. I have one set imperial and one set metric and none of them fit. I would have expected imperial since they are measured "across the flats"the sizes sold here are 1/8",5/32",3/16" and so on. I would think the sizes I need are in 1/64"increments. can anyone give me exact sizes and I will get down to a high class tool store. Thanks in advance. Best regards Billy |
Earnest Bovine Member From: Los Angeles CA USA
|
posted 07 September 2005 09:17 AM
profile
Using three pairs of glasses and the old electron microscope I came up with these Zum allen wrench sizes:9/64 hold knee lever on its support 7/64 hold knee levers on cross shafts, adjust knee lever position; limit the backward rotation (slack or slop) of cross shafts for pedals (not knee levers) 3/32 hold rod pullers onto cross shafts 5/64 hold the ends of the push rods of knee levers that push to the right |
Mike Sweeney Member From: Nashville,TN,USA
|
posted 07 September 2005 09:47 AM
profile
it takes a 7/64 wrench for the primary lower [split tuning] screws. |
Billy Murdoch Member From: Glasgow, Scotland, U.K.
|
posted 07 September 2005 10:19 AM
profile
Thank you Earnest and Mike for your invaluable help,can you perhaps now tell me how to play like John Hughey?.Best regards Billy |
Paul Norman Member From: North Carolina, USA
|
posted 07 September 2005 05:26 PM
profile
I can tell you. Buy all of his CDS DVds you can get or afford and study day and night till you sound just like him. |
David Doggett Member From: Philadelphia, Pennsylvania, USA
|
posted 07 September 2005 07:14 PM
profile
I just get a handful of different allen wrenches in front of me and keep trying them until one fits. Even if I knew the correct size, I can't read those little tiny numbers on those little black wrenches. |